I have no objection to anyone using my card designs but my Blog and I would appreciate a mention. Thank you to all who read my Blog and leave a comment. I really do appreciate every one of them and do my utmost to reply as soon as possible.
Crafty hugs to all!


Sunday, 26 April 2015

Elegant Ladies with a bit of Grunge!!

Hi Folks!  Hope you are well!  I am finally getting round to blogging a birthday card that I made back in March. I have been busy with other projects and I forgotten to finish writing this one up...sorry! (I have a few more like that too...note to self - get busy!)

So starting with a Blank Piece of Gelli Card I created this little scene using Grunge Paste, Clarity Stamp Elegant Ladies Stencil (set of 3) a selection of Distress Re-Inkers and some ink pads along with a Brayer.

Tape Low tack Masking tape around blank card to create a white border.  Stamp Easel into place using Archival Ink. Stamp again onto Post-it note for mask, cut out and place over stamped image.
Place a piece of torn copy paper over the top half of the card and use a Brayer along with Adirondack ink Pads to add colouring of choice to the bottom.  Take copy paper, place it over the 'floor' moving it up slightly to get a blank band.  Ink up Brayer and add Denim to the top right corner - coming down and to the left. Ink up Brayer again, this time came in at the diagonally opposite corner - coming up and to the right.  This way you can achieve the look of light filtering through a window.

Remove the Mask from the Easel as the next step is creating the image on the Easel.  Make your own Ink Pad by stamping onto Cut and Dry Foam with Black Archival ink.  Then colouring with drops of Distress Re-Inkers.  The ink will bleed and you can achieve a lovely blended effect.











Let the inks soak in a bit and then stamp a little scene onto the easel.
Use a piece of torn copy paper, makeup sponge and Adirondack inks to create a mini set of hills in the background.
Take a note of which inks and stamps used on a piece of card and put these all together with the stamps in an airtight plastic bag for future use.
You can add in a Dado Rail if you wish at this stage on the upper part of the card.  You can do this by colouring in a band or add a coloured Peel-off.
The next step is to add the ladies with the Grunge paste



Tape Stencil securely into place and add Grunge Paste. Let this dry for about 10 minutes and then go into the Grunge Paste with a fine ball tool to mark of details - hair, clothes and to cut away the grunge paste at the knee.




Once dry add the other lady...I wanted them to be standing closer or I could have grunged them at the same time.
You can colour the Grunge Paste using a variety of mediums from Ink, Acrylic Paint and Pencils.  For these though I used my ProMarker Pens. Add extra shading by taking a Light Gray Pen or Pencil around one side and underside of all images.  You can also at this stage add highlights by scraping away the edge of the Grunge Paste if you wish.


Shading has also been added roughly under the ladies feet with Cool Gray 1 ProMarker.
Remove the Masking Tape from around the edge of the card.  Use a permanent FineLiner to draw a rough edge around image.  I draw around one way and then come back around the other way. Using either ProMarkers with a Fine Nib or Spectrum Noir Pencils colour in the spaces between the lines.
Matt and Layer onto a complimentary background and then mount onto a Card Blank.
Add a string of Flat Backed Pearls around the edge to finish.  I used double threaded dressmaking pearls.  You can attach them using a glue or strong double sided tape.

Apart from the Card Blank, background layer and Pearls all items were sourced from Claritystamp  http://www.claritystamp.co.uk/

Large Easel Stamp, a post-it note mask. Archival Ink - Coffee

Homemade Ink Pad with Distress Re-Inkers - Forest Moss, Dried Marigold, Ripe Persimmon, Crushed Olive and Squeezed Lemonade along with Tree, Mantle and Floral Verge stamps.

Makeup Sponge, Brayer. Adirondack Ink Pads - Denim and Lettuce.

Scrap paper for hills. Scrap paper for Skirting Board and Dado Rail.

Thank  you for popping in and having a peek.  Any questions please leave a comment and I will get back to you.

Happy Crafting

Emma xx

Saturday, 18 April 2015

A little bit of Parchment Craft along with Clarity Stamp

Hi Folks! Hope you are all having lovely weather and enjoying yourselves.  I have been busy with cardmaking and a little bit of grungy playing ( that's for another day)  but I have also overdone it a bit on the training for Ben Nevis and managed to mess up a bone in my foot (I am ok but did have to finally give in to painkillers which I hate to take)  So while I was sitting resting my foot (it is hard to sit with your foot up above your pelvis without restraints lol) I decided to have a play with my parchment.  Barbara Gray featured the Floral Corner Set on Create and Craft TV at the beginning of the month and as I already had it I was quite chuffed.  I made two cards both quite different but for this blog post I will share the parchment one and maybe pop a picture on the end of the other card!


On Copy paper. I drew a 6 x 6 square with an inner 1/2 inch border in Black Pen.  I stamped in Cobalt Archival Floral Corner and Flower from Clarity Stamp.
I traced a small flower and a couple of leaves using a Blue Micron Pen in one corner. I then drew in a leafy branch. I drew in a few Half Moons around one corner and then changing to a Black Micron Pen I added dots around the outer edge.


Simple, Blue = Embossing, Black = Piercing
Tools:
Lightbox, Embossing Mat, Pricking Mat, Fine Ball Tool, Medium Ball Tool, One Needle and a Two Needle Tool. Tumble Dryer Sheet. Tape, Parchment Grid, Parchment Scissors. White Pergamano Pen, Parchment and a selection of Blue Spectrum Noir Pencils.

I traced the design onto Parchment with the Pergamano Pen. When it came to tracing the outer edge I just moved my Parchment along the design I had drawn. I smooched the back of the Parchment with the Tumble Dryer Sheet. I used a Fine Ball Tool to Emboss.  I then shaded in the flowers etc with the SN Pencils.  I then went back over the Embossing with the Ball Tools to whiten the outlines and to the tips of the Flowers and Leaves.

I turned the Design over and with my Finest Ball Tool, scribed the sentiment, smooched again, with Medium Ball Tool Embossed from the back, coloured the letters then back in again with a Fine Ball Tool to Whiten the outline and shade in the tops of the letters. 



Next step piercing.  I placed Piercing Mat on Lightbox, then Parchment Grid, Pattern, Parchment. I pierced the 8 Corner Holes, removed the Pattern and got on with Piercing using the Corner Holes to guide me onto straight lines. I pierced every 2nd hole apart from the corners where I have a run of 3 consecutive holes on the Inner line and a run of 4 on the Outer line. I shallow pierced, removed Parchment from Grid and then went back and re-pierced deeper with my One Needle Tool.

Next Step Cutting. Using a Two Needle Tool I pierced around all the inner gaps between the Flowers and Leaves, then I cut using Pergamano Scissors.


Next Step Outer Edge.  With my Piercing Mat on my lightbox and Two Needle Tool I pierced around each Scallop and then went back around with my Pergamano Scissors to cut out.  (I couldn't resist a peek at the edge while I was doing it).  I Traced, Coloured, Embossed a separate Single Flower and attached over the one already within the design with Pergamano Glue.


I coloured a piece of Super Smooth (7 x 7) with Denim Adirondack Ink and a Clarity Stencil Brush. Double Sided Tape on the back and mounted onto an 8 x 8 Card Blank to which I then attached the finished  Piece with Pergamano Glue.

Just a few more pics to see the details a bit better (I am not the best photographer)




I decided the next day that the card needed something else and added some flat backed pearls to the opposite corners.  Sorry no full picture as my camera died on me and the card has now been sold...think I will do another one as I did enjoy making this one!


Final Picture!!

The other Card


I think I may be back in my Blue Phase!!

I hope that you enjoyed reading my step by step (I really hope you understand it too).  I have enjoyed sharing it with you all and would very much welcome your feedback.

I'm off to Edinburgh for the Ross Papercraft Show at Meadowbank on Saturday.  Determined to spend my husbands hard earned cash and get in a visit to my Daughter.  

Have a good weekend and Crafty Hugs to All !!!

p.s.  I would like to point out that the Calligraphy Work on my Parchment Design was from a template that I had in my stash. At the time of publishing this post I was not aware that it was in fact a piece of Calligraphy by the wonderful, talented Anne Quinn.  I would just like to give her the credit due for its design.  Click on her name and check out her site where you can see her work and learn more about her.
Thank you.
Emma xx

Wednesday, 1 April 2015

Clarity Stamp Challenge April 2015

The theme of this months challenge is
WEE FOLK
Clarity Stamp has brought out 4 sets of Wee Folk stamps recently and Barbara Gray has very kindly given us ladies on the Challenge Design Team two of the Fairy Wee Folk Sets.  (Perfect Timing Barbara and thank you very much indeed) As soon as I had the stamps in my hand my first thought that came to mind was fairies at the bottom of the garden and the old photos that were taken by Elsie Wright and her cousin in 1917.  
So I decided to create a scene of my own using the FILM STRIP STENCIL and the Fairies to represent the photos.


















The first thing  was to make a mask of the FILM STRIP.  I did this by inking up the STENCIL with Coffee Archival Ink Pad and a BRAYER, then putting it through an embossing machine, transferring the ink and the outline to a piece of paper. I cut out the holes for the sprockets with my craft knife before cutting around the outside of the mask.

inked stencil
stencil mask





I re-inked the STENCIL and placed it centred on an A4 sheet of  Super Smooth paper and put this through my BigShot. I cleaned the stencil using Nail Polish Remover.  I taped the FILM STRIP MASK over this 1st PRINT.  I re-inked the STENCIL again, placed it ink down OVER the MASK at an angle, Placed a piece of copy paper over the top and used a BRAYER to roll over adding pressure, thus transferring the ink to the 2nd PRINT.  I then repeated the process once again, leaving the FILM STRIP MASK in place and turning the actual STENCIL to a different angle to get a 3rd PRINT



The reason behind this - when you put the stencil through an embosser, it leaves the outline marks that you want,..but if you move it and put it back through the machine you would now have more outline marks but these would be crossing over what you have already embossed and that would ruin any scene that you want to create as you would end up with scored lines everywhere which would show up when stamping or brushing with ink.


Keeping the FILM STRIP MASK in place I set about stamping in my WEE FOLK.  As you can see from the picture I also made masks for them too. I used MOONLIGHT WHITE - ARCHIVAL BRILLIANCE INK to stamp my FAIRIES into place. (unfortunately the flash on my camera prevents you seeing the detail in the fairy wings). I lifted the FILM STRIP MASK, covered the FAIRIES with the post-it note MASKS, then taped the FILM STRIP MASK back in place over the center piece of FILM STRIP.


I used COFFEE ARCHIVAL INK, 1st and 2nd gen. Along with OLD PAPER and ANTIQUE LINEN - DISTRESS INKS to stamp the FLOWERS, TREE BRANCH and MUSHROOM also for the shading to give the 'aged' look.  I used more post-it notes to protect the other pieces of the  FILM STRIP.  I also made sure to stamp through the sprocket holes so that I would get the layered look.


All I did to create the 'photo's was just to simply move the STENCIL to the strip I was working on and protect the edges with the post-it notes and cover the next layer with a mask.



Once I had finished stamping and shading I then darkened the edges of each strip by using the edges of the Post-it notes either side of the straight lines and using a makeup sponge and the Coffee Archival I just dabbed until I got the effect I wanted.  (I used large Post-it notes from WH Smiths)


I used SLATE - ADIRONDACK to add shadow around the each of the FILM STRIPS. I also re-used the post-it notes once again to mask the strips so that I could stamp in the TREE BRANCH and the WORD STAMPS in the background.  Finally I used a CLARITY STENCIL BRUSH and COFFEE - ARCHIVAL INK to give a light shading to the background.


This piece will now be fixed onto the inside cover of an art journal that I have been asked to make for a Children's Illustrator. Mmmm, I think I will use the ELVES for the inside back cover!

Well I hope that you like it and that it gives you a little bit of inspiration. I also hope that it encourages you to take part in the Clarity Stamp Challenge this month too.  Pop in and check out all the lovely designs from the other ladies on the Design Team.

Challenge 26
Wee Folk
Stamping and stencilling must be with Clarity Stamps and Stencils
£50 Clarity Stamp gift voucher for the Winner



Best of luck to everyone

Happy Crafting

Emma xxx